The short answer: put cold or gently warmed milk in a tall container, hold the whisk just under the surface for a few seconds to add air, then lower it until the milk spins smoothly, and stop when the volume has about doubled. KitchenAid says a handheld wand takes about 30 seconds.
We sell the GROSCHE E-Z Latte handheld frother, so read this with that in mind. The technique below comes from KitchenAid, a barista-written guide at Whole Latte Love and the frother maker Subminimal. They disagree on a couple of points, and we say where.
KitchenAid says a handheld wand takes about 30 seconds, and you should stop when the milk has roughly doubled in size, filling your container only about one third full.
KitchenAid says to froth cold milk, since heat breaks down fats and proteins, while Subminimal warms milk to 55 to 65°C first. Both agree not to go much past 70°C.
Whole Latte Love suggests stopping at 140°F and no hotter than 155°F, because hotter milk degrades both the texture and the flavour of the foam.
Whole milk gives the thick, velvety foam KitchenAid recommends. Skim froths faster with bigger bubbles, and oat milk foam is creamy but less stable, so use it quickly.
How Do You Froth Milk With a Handheld Frother?
Add air at the surface first, then spin the milk below it. Subminimal calls the two stages stretching and polishing, and the steps below follow its method with KitchenAid's fill and timing advice.
- Pick a tall, narrow container: Subminimal says wide mugs splash and make big bubbles, and KitchenAid says to fill about one third full because frothing adds a lot of volume.
- Add enough milk: Subminimal suggests at least about 1.5 inches (3.8 cm) so the whisk head stays covered. Too little milk is the usual cause of giant bubbles.
- Stretch: Hold the head just under the surface and switch it on. You should hear a soft tearing sound while air goes in. Keep this short for a latte and longer for a cappuccino.
- Polish: Lower the head and move it slowly toward the side until the milk turns in a steady whirlpool and the loud hiss fades. Small movements beat pumping the head up and down.
- Stop and tap: Switch off with the head still in the milk to avoid spray. Tap the container on the counter once or twice, then swirl so foam and milk look like one thing.
- Pour and rinse: Pour soon, since Subminimal says foam that sits can split into dry froth on top and thin milk below. Rinse the whisk right away.
Should You Froth Milk Hot or Cold?
The sources disagree, so pick based on your drink. KitchenAid says always froth milk cold, because heat can break down fats and proteins and lead to less stable foam, and any frothing adds a little heat through friction anyway.
| Source | What it says | Type |
|---|---|---|
| KitchenAid | Always start with cold milk, straight from the fridge | Appliance maker |
| Subminimal | Handheld frothers mostly do not heat, so warm the milk first to about 55 to 65°C (130 to 150°F) | Frother maker |
| Whole Latte Love | For steaming, aerate before the jug feels warm, around 100°F, then texture up to 140°F | Retailer, barista tips |
A practical way to read this: froth cold if you want cold foam for an iced drink, and if you want a hot latte, use a warmed jug or a steamed method and keep the heat in the ranges below. If you are unsure, start cold, as KitchenAid does, and see how the foam holds.
What Temperature Should Frothed Milk Be?
Aim for hot to the touch but not simmering. Whole Latte Love says to stop at 140°F for the best taste and no hotter than 155°F, because temperatures past that range degrade both the texture and the flavour of the milk.
- Subminimal: Targets about 55 to 65°C (130 to 150°F) and says past about 70°C the proteins toughen, sweetness drops and the foam turns thin.
- Whole Latte Love: Stop at 140°F for the best taste and no hotter than 155°F.
- In practice: These ranges overlap around 60°C (140°F). A kitchen thermometer helps at first, and browned milk at the bottom of the pan means the heat was too high, per Subminimal.
How Long Does It Take to Froth Milk?
About 30 seconds with a handheld wand. KitchenAid says to move the wand up and down through the cup for roughly that long and to stop when the milk has about doubled in size.
- Manual plunger frother: KitchenAid says to expect about 30 seconds of rapid plunging.
- Steam wand: KitchenAid says only around 5 to 10 seconds.
- Go by the milk, not the clock: Subminimal says total time is often half a minute or a little more, and to stop when the volume has risen and the surface looks like gloss rather than soap suds.
What Milk Froths Best?
Whole milk. KitchenAid calls it the ideal milk for frothing, with a good balance of fat, sugar and protein, giving a thick, velvety result that takes a little longer to build volume.
- Skim milk: KitchenAid says it froths quickly with larger bubbles, which you can knock out by tapping the container.
- Almond milk: KitchenAid says it has more fat than some plant milks and gives results similar to 2% milk, with fairly stable foam.
- Soy milk: KitchenAid says it gives a light, airy result suited to drier foam.
- Oat milk: KitchenAid says it froths creamy and slightly sweet but the bubbles are less stable, so use it quickly. Subminimal calls oat the plant option many people reach for first.
What Container and How Much Milk Should You Use?
A tall, narrow container, filled about one third full. KitchenAid says frothing increases volume significantly, so leave room, and Subminimal says a narrow jug keeps the vortex that pulls foam down and polishes it.
- Depth: Subminimal suggests at least about 1.5 inches (3.8 cm) of milk so the head stays buried.
- For our frother: The GROSCHE listing says to add a couple of ounces of milk to a tall glass, which keeps the milk from splashing while the whisk runs.
- Fresh milk: Subminimal says fresh milk foams better than milk that has sat open for days.
Featured in this guide
GROSCHE E-Z Latte Milk Frother – Handheld Turbo Frother
Handheld battery frother with an 18/8 stainless steel whisk head. Whips a couple of ounces of milk into thick foam for lattes, cappuccinos, hot chocolate and cold foam. Two AA batteries not included.
Shop now → ✓ 30-day money-back guarantee · Free shipping over $75Can You Froth Milk With the GROSCHE E-Z Latte?
Yes, that is what it is made for. The GROSCHE E-Z Latte is a handheld turbo frother with an 18/8 stainless steel whisk head that the listing says whips a couple of ounces of milk into a thick froth, including for cold foam and hot chocolate.
- Power: It runs on two AA batteries, which are not included. There is no cord and no charging base.
- Heat: The listing describes a motor and a whisk head and does not mention a heating element, so warm the milk beforehand if you want a hot drink.
- Care: Rinse the whisk head under hot water straight after use. Do not submerge the handle in water.
- Colour: It comes in black or red. At the time of writing the red is the colour in stock.
- Pairs with: The listing suggests it goes well with a moka pot for a home latte, and we cover that in our moka pot guide.
Why Is My Frothed Milk Bubbly or Flat?
Usually too little milk, too much heat or too much stabbing with the whisk. The fix depends on what the foam looks like.
- Big, soapy bubbles: Subminimal says too little milk is the usual cause, and that stabbing the head up and down punches in jumbo bubbles that will not go away.
- Foam collapses fast: Overheated milk gives thin foam, per Subminimal, and KitchenAid says heat can break down fats and proteins and make foam less stable.
- Dry froth on top, thin milk below: Subminimal says foam that sits too long can split, so pour soon after tapping and swirling.
- Too much air in a latte: KitchenAid says latte milk should look glossy, like wet paint, and that tapping the container knocks out larger bubbles.
What Can You Do With Frothed Milk?
Use it in coffee drinks, hot chocolate or tea. KitchenAid says frothed milk adds a light, slightly sweet creaminess that balances coffee's bitterness, and that a latte wants glossy milk while a cappuccino wants a defined layer of foam on top.
- Coffee drinks: Pour over coffee from a French press or a moka pot, or over an iced base.
- Cold foam: For iced coffee, froth cold milk and spoon it on top of a cold brew.
- Cappuccino: Subminimal says to hold some foam back with a spoon, then spoon it on.
Frequently Asked Questions
How do you froth milk without a steam wand?
Use a handheld whisk frother: hold the head just under the surface to add air, lower it until the milk spins, and stop when the volume has about doubled, around 30 seconds per KitchenAid.
Is it better to froth milk cold or warm?
KitchenAid says to always froth cold milk, while Subminimal warms milk to about 55 to 65°C first for handheld frothers. Both avoid going much past 70°C.
What is the best milk for frothing?
KitchenAid calls whole milk the ideal choice, with a good balance of fat, sugar and protein. Skim froths faster with bigger bubbles, and oat froths creamy but less stable.
How hot should frothed milk be?
Whole Latte Love says to stop at 140°F and no hotter than 155°F. Subminimal targets 55 to 65°C and says past about 70°C the foam turns thin.
Does the GROSCHE E-Z Latte heat milk?
The product listing describes a motor and a stainless steel whisk head and does not mention a heating element, so warm the milk first if you want a hot drink.
Shop the GROSCHE E-Z Latte Milk Frother — 30-Day Guarantee