• Founded By

    Environmental Engineers

  • Made in Montréal

    Serving Canada Since 2010

  • Free Shipping

    On Orders $75+

  • Easy Returns

    Money Back Guarantee

How to Mop Floors: What the Sources Agree On

A Sampson Eco-Strips Floor Cleaner box on a tile and wood floor beside a galvanized mop bucket with a strip mop and a folded linen cloth in a bright kitchen

Diana Trasente |

The short answer: sweep first, wring the mop until the floor looks damp but not puddled, mop in sections, and finish with a clear-water pass. This guide pulls together what three cleaning sources say about mopping, including where they disagree.

We sell Eco-Strips Floor Cleaner, so read this with that in mind. The method comes from the sources linked below; our own product is covered in one section.

Key takeaways

Sweep or vacuum before you mop. Instructables says a mop only cleans the surface and will push loose debris around instead of picking it up.

Wring the mop until the floor looks wet but has no puddles. Pine-Sol says damp, not saturated, and Seventh Generation says to dry hardwood right away with a dry towel.

The sources disagree on vinegar: Instructables says it suits tile but not wood or stone, while Seventh Generation says a vinegar shine only works on hardwood. Check your floor maker's advice.

Finish with a clear-water pass. All three sources describe a rinse step to remove leftover cleaner, and Pine-Sol says it clears away film or residue.

What Is the Right Way to Mop a Floor?

Remove loose dirt, mop with a well-wrung mop in sections, then rinse with clear water. Seventh Generation, Instructables and Pine-Sol all follow that order, with small differences in the cleaner they use.

  • Dry first: Seventh Generation starts with a broom to remove all dirt and debris.
  • Then wet, in sections: Instructables divides the floor into roughly 5 ft by 5 ft sections and starts with the one furthest from the entrance.
  • Then rinse: Pine-Sol says to mop over the floor again with a damp mop in clean water to rinse away remaining cleaner.

Do You Need to Sweep Before You Mop?

Yes. Instructables explains that the point of mopping is to clean the surface of the floor, not pick up debris, and that a mop will just push crumbs around. Seventh Generation also starts with a broom.

  • Clear the room: Instructables suggests moving chairs, tables and other items out of the room as far as you can before you start.
  • Keep traffic off: It also says to keep people and pets off the floor while you mop, since walking over it undoes the work.

How Wet Should a Mop Be?

Damp, not soaking. Pine-Sol says to wring the mop so it is damp but not completely saturated and not to let liquid pool, and Instructables says the floor should look wet after a pass but have no puddles.

  • Trial and error: Instructables says how much to wring takes a little practice. If puddles form, wring harder.
  • Hardwood: Seventh Generation says to put a dry towel under the mop and dry hardwood floors right away. On tile it calls drying optional.
  • Change the water: Instructables says to pour out the bucket and mix a fresh batch once the water becomes substantially dirty.

What Should You Put in a Mop Bucket?

It depends on the floor, and the sources do not fully agree. All three use a mild cleaner in warm water; the disagreement is mostly about vinegar. Always follow your floor maker's advice first.

  • Dish soap: Seventh Generation uses 5 to 7 drops of dish soap in a bucket of water. Instructables uses a quarter cup per 2 gallons for wood and linoleum.
  • Vinegar: Instructables says tile can take a half cup of vinegar per gallon every few months, but not wood or stone. Seventh Generation says a vinegar-and-water shine only works on hardwood. That is a direct contradiction.
  • Stone: Instructables says to use the stone cleaner recommended when the stone was bought, and not lemon or vinegar cleaners, which can discolor grout or eat through the sealer.
  • Branded cleaners: Pine-Sol notes that dilution depends on whether you have a concentrated or non-concentrated formula, so read the label.
  • Never mix products: Health Canada warns that mixing bleach with other cleaning products can release toxic gases.

Should You Rinse After Mopping?

With soap or a conventional cleaner, the sources say yes. Seventh Generation says to go over the floor with a new towel and only water to remove the soap, and Pine-Sol says a second pass clears away film or residue.

  • Instructables: Pour out your solution, fill the bucket with plain water, give the floor a little rinse and let it air dry.
  • Our listing: The Eco-Strips product page says its solution does not leave a sticky film, so no second-pass rinse is required. That is the maker's statement; the three sources above are describing soaps and general cleaners.

How Do You Mop a Floor Step by Step?

Sweep, mix the solution, wring the mop, mop in sections, rinse, and dry. These steps combine the points the three sources share.

  1. Clear and sweep: Move items out and remove loose dirt with a broom or vacuum.
  2. Mix the solution: Use a cleaner suited to your floor, in warm water. Instructables says 2 gallons should be plenty for about 200 sq ft.
  3. Wring the mop: Dip the mop and wring it until the floor will look wet with no puddles.
  4. Mop in sections: Instructables says to use straight passes with a sponge mop and a circular motion with a strip or string mop.
  5. Rinse and dry: Go over the floor with clear water, then let it air dry or towel-dry hardwood right away.
Eco-Strips Floor Cleaner Mopping Soap Strips - Sampson Eco Shop

Featured in this guide

Eco-Strips Floor Cleaner

Dissolvable floor cleaner strips, 60 per pack, for the surfaces named on its product page (ceramic, sealed stone, sealed wood).

Shop now → ✓ 30-day money-back guarantee · Free shipping over $75

Can You Use Eco-Strips Floor Cleaner in a Mop Bucket?

Yes, that is what it is made for, on the surfaces its listing names. The listing for Eco-Strips Floor Cleaner names ceramic, sealed natural stone and sealed wood, and says to drop one strip into about 5 L of warm water.

  • Dose: The listing says one strip per roughly 5 L bucket for a deep clean and half a strip for routine mopping. A pack holds 60 strips.
  • Dissolve time: It says the strip dissolves in 30 to 60 seconds in warm water; cold water works but is slower.
  • Wood: The listing says to wring your mop well on sealed wood, which matches the advice above.
  • What we do not claim: We do not claim it suits unsealed wood or laminate. See our laminate guide for why we do not recommend it there.

How Do You Keep a Mop Clean?

Dry it out after every use. Instructables says a wet mop put back in a closet can grow mold, mildew and bacteria, and that hanging it over the sink for an hour is quite effective.

  • Dry the bucket too: Instructables says to dry out both the bucket and the mop.
  • Replace the head: If the mop becomes extremely dirty or moldy, Instructables says you can most likely just replace the head.

Should You Check Your Floor Maker's Advice First?

Yes. Instructables says the right method depends on the floor material, and Pine-Sol's own label warns against using its cleaner on marble or wood that is unfinished, unsealed, waxed or oiled.

  • Know your surface: Instructables covers wood, stone, tile and linoleum separately because the cleaners differ.
  • Test first: When unsure, try the cleaner on a small hidden area before mopping the whole room.

Frequently Asked Questions

Should you mop with hot or cold water?

The sources we read specify warm water: Pine-Sol uses warm water and our listing says warm water dissolves a strip fastest. None of the three gives a hot-water rule, so follow your floor maker's advice.

Can you mop without sweeping first?

You can, but Instructables says the mop will just push debris around instead of picking it up, so sweep or vacuum first.

Is vinegar good for mopping floors?

It depends on the floor and the source. Instructables says it suits tile but not wood or stone; Seventh Generation says a vinegar shine only works on hardwood.

Do you need to rinse after mopping?

With soap or a conventional cleaner, the sources recommend a clear-water pass. Our Eco-Strips listing says no second rinse is required.

How do you dry a mop?

Instructables suggests hanging it over the sink for about an hour, and drying the bucket as well, so it does not grow mold or mildew.

Shop Eco-Strips Floor Cleaner — 30-Day Guarantee

Related Articles

Leave a comment